Though it’s possible to pick a high-gloss vinyl floor covering, with time, the floor loses its moist appearance. Or, possibly the vinyl flooring in your home came with a matte or low-gloss finish you wish to punch up. Some vinyl floor manufacturers recommend particular products to clean and keep your floor’s end, but product labels can tell you if a specific solution works for your type of floor covering. With only a little bit of time and work, it is possible to restore a plastic floor’s end to make it seem new again and shield it from harm.
Product Choices
Before applying any item to your vinyl floor, verify it can be used on vinyl. To create a high-gloss sheen, then pick an acrylic product that contains polyurethane or the kind of industrial product that’s used in hospitals, stores or office buildings. Commercial products provide greater protection and last more compared to a great deal of retail products, but most of them cost more and arrive in larger containers compared to retail products.
Clean Up It
With thoroughly cleansing the floor, the first step to obtaining that high-gloss sheen begins. The floor requires a comprehensive cleaning before applying the high-gloss coat; otherwise, debris and dirt can embed in the end. A dust mop, broom and dust pan or a vacuum cleaner removes the debris and dust. Run a light wet mop over the outside to eliminate stains and clogs; for ground-in dirt, then use a soft-bristle brush. Abrasives or products that can scrape the vinyl’s surface.
Eliminate Old Finish
After cleaning the ground, remove the old finish, using a stripping product designed especially for your floor. Check the flooring manufacturer strippers. A silk mop is the easiest way to use the stripper throughout the vinyl floor in an even, but thin coat. Let the stripper sit. For tough finishes, wash the floor with a rotary scrubber fitted with wiping pads. Eliminate the sludge material that results in the emulsification, then rinse with water. Allow the floor to dry.
Apply New Finish
When the old end is gone, use the new end working with a sponge mop. Work from 1 side of this room to another, applying it in light, but strokes. Keep the room at 65 degrees Fahrenheit for at least 48 hours to guarantee the item dries and cures. Apply another coat, if desired, following the floor is dry to your touch, after about one hour. Following coats take as much as 2 hours or longer. Do not wash the ground for as much as five days to permit the end product to bond and cure.
Special Considerations
Some vinyl manufacturers advise you not to use mop-and-shine products, since they may leave a filmy residue on the surface of the ground. Avoid abrasives or products that can scratch the surface of the vinyl. A woven carpet with no dyes or a vinyl-backed rug strategically placed near the entrance to the room can help keep dirt from getting tracked onto your chosen vinyl floor.