Double rods are employed to give your windows a two dimensional appearance; they let you join two distinct coloured drapes or material kinds. Two poles, about 2-inches apart, are held in place by unique brackets. Installing the mounts is a task most do it yourself homeowners with tools and basic woodworking skills can finish. In less or a single hour, it is possible to give your windows a classy, fashionable appearance.

Put a step ladder alongside the window where the curtain rods will soon be set up. Climb the ladder before you’re eye level with all the very top of the window-frame. Using a tape measure, measure two to three inches to the not in the top-right corner of the window-frame and 4″ above. Put a reference mark. Repeat the procedure with all the top-left corner of the window-frame.

Hold a carpenter’s level from the wall between the reference marks to make sure the mounts will probably be right aligned when installed. If needed, make alterations and note the wall.

Place a mount in the benchmark mark that is best and plainly mark to the wall equally holes. Generally there are 2 holes per mount. Make use of a stud-finder to find out whether the mount is going to be set up right into a wall stud. Repeat the procedure using the benchmark mark that is left.

Drill pilot holes at every benchmark mark. Make use of a drill designed using a 3/32-inch drill-bit if the mount screws will be be installed into wall studs , a 1/4-inch drill bit. Insert wall anchors into each hole if you’re screwing the screws into dry wall.

Align the holes of a mount with all the holes that have been drilled in the wall. Make use of a screw-driver and screw the mount screws that are supplied to the wall or stud anchors. Tighten the screws fully. Repeat the procedure with all the holes on the aspect of the windowframe.

Attach to the pole which will be closest to the wall. Generally the thinner pole supports the light weight or shear drapes and goes closest to the wall in the event both poles are of diverse thicknesses. Put the stick on the mount. Repeat the method for the stick.

See related